Perennial off air to the water Power users should always check whether the air to solar hot water heaters, exceptions should be sent to the maintenance point of repair. Air to water heaters use a normal
Perennial off air to the water Power users should always check whether the air to water heaters, exceptions should be sent to the maintenance point of repair. In the case of air to water heaters use a normal, every three years to the designated repair point to replace a thermostat and heater.

    Cleaning, the interior every six months once the cleaning method is to turn the power off, close the inlet valve, then open the outlet valve, safety valve on the drain switch rotated 90 degrees counterclockwise, natural row of the net air to water heaters, water and precipitation material, and then after the water cleaning. Cleaning is completed, then the drain switch back into place, pay attention to is filled with water before power. .

    Less water, such as showers, must promptly clean up the clogged debris to ensure the smooth export to extend the life of the air to solar water heaters. Air to water heaters installed product is installed and used incorrectly, cause the product does not work, so that consumers misunderstood product quality problems, therefore, it is necessary to note the following four issues:

    1) without mixing valve. Air to water heaters do not need to use a mixing valve, mixing valve to hit the middle there will be cold, hot water and mixed outflow, then the hot water flow become smaller, causing the air to the water heater temperature is too high, appeared super- temperature (thermostat action), change the phenomenon of hot and cold water. Staff should inform the customer of the mixing valve and boot directly to the hot water side, without mixing cold water, this will make the life of the product longer and difficult to scale

    2) control the flow of water. Installation of air to the water heater must be factory equipped with special shower, air to water heaters under normal operating conditions, can adjust the water flow or an increase of high-end bit to enhance the water temperature. General users do not have the habit of control faucet flow, resulting in water temperatures of less than a predetermined effect

    3) Install the filter. The water heater must be installed in the inlet filter, a small amount of debris due to water, so as not to get stuck floating magnetic (dry, not heated) or plug the shower (the water is getting smaller and smaller). If the filter is clogged, make the flow rate decreases, the smaller water floating magnetic action air to water heaters can not be heated. Remove the filter to use for some time cleaning, you can use

    4) Check the position of the floating magnetic. Installation of air-water heater, the staff must remember to check the floating magnetic "is in the bottom of it is free active in order to ensure the normal use of air to water heaters. Floating magnetic the hydropower linkage switch to open the automatic heating valve, turn off the water to stop heating, if any debris stuck floating magnetic, air to water heaters will appear dry or heating phenomenon, cleared away the debris on the floating magnetic to work properly.